Treasure Cove TC-9700 Bedienungshandbuch Seite 1

Treasure Cove Metal Detector Professional 9700 OWNER’S MANUAL www.Treasure-Cove.com 805-658-2328

10 get ALL METAL mode. LCD displays ALL METAL at the left lower part of the screen. Press GROUND TRAC several times to allow the unit to stabilize wh

11 2. When adjusting GND BAL counterclockwise, be careful to turn it in small increments—This will assure that you achieve optimum condition for ope

12 5. In modes of DISC, NOTCH and AUTO-NOTCH, slowly sweep a sample of the material you want the detector to find (such as a gold ring or a coin) 4~

13 Searchcoil Sweeping Hints: z Never sweep the searchcoil as if it were a pendulum. Raising the searchcoil while sweeping or at the end of a sweep

14 z False signals can be caused by trashy ground, electrical interference, or large irregular piece of junk metal. z False signals are usually bro

15 z The angle of the target buried in the soil. z The depth of the target. z The level of oxidization of the target. z The Size of the target. z

16 TROUBLESHOOTING The following troubleshooting steps may assist you in case you’re having problems with your metal detector. YOUR DETECTOR IS EMIT

2 MAIN FEATURES The detector has two distinct systems: 1. ALL METAL No-Motion Mode: In this setting, detected targets will cause the detector to so

3 4. Unscrew the knob on the search coil and remove the knob connector. Insert the stem and align the holes on the search coil bracket and the stem.

4 z Use only fresh alkaline batteries of required size. z Do not mix the old and new batteries or different types of batteries. Follow these steps

5 phone Listening Safely z To protect your hearing, set the volume to the lowest setting before you begin listening, adjust the

6 PANEL WITH TOUCHPADS 1. MODE—lets you choose detection modes. 2. ADJ—to adjust sensitivity and the range of discrimination 3. ENT—to confirm ac

7 target. If the detector receives a strong signal, the arrow appears steadily. If the signal is weak, the arrow blinks or does not appear. Note:

8 When the unit is in DISC, NOTCH, AUTO-NOTCH modes, its audio identification system automatically classifies metal objects into three categories wit

9 b. NOTCH-- to ignore the metal type you do not want, or to accept the one you want. Press MODE to NOTCH mode. LCD displays NOTCH on the screen. The